What it takes to complete a garage door installation is not actually a straightforward guideline. It can confuse someone who is not really a technical type person. The garage door is large and bulky equipment which could be dangerous if the project is not accomplished properly. Normally home improvement experts suggest that garage door installation should be left to the professional garage door installer including garage door installers in Coweta County to accomplish unless the homeowner possesses certain skills.
Manual garage doors are raised and lowered without the support of an electric motor. Depending on the material used in the construction, they can be relatively light or heavy. On the other hand, automatic garage doors are relatively heavy. Therefore, lightweight garage doors are not suitable for homeowners who really want to have thick wooden garage doors.
When it comes to installing a manual garage door there are several actions involved in the process that need to be followed accordingly. First of all, you need to install the “flag brackets” and “horizontal angle tracks”. Once those are installed they should be fixed securely to the jamb of the garage door.
It is also essential to attach the torsion tubs and springs. Make sure that springs are loaded into the right bracket. Install the drum on the left side first and then secure the needed drum on the right side. After completing these steps, it is time to fit the tube retainer and wind the spring securely. Remember, the garage door spring is a dangerous object because it is placed under a lot of tension.
When it comes to installing an automatic garage door, make sure that you have a partner to support you. If you have neither expertise nor a partner, it might be a wise decision to hire a professional garage door installer to do the job. If you are still in the game, start your project by installing tracks correctly to the “drive unit” and then assemble the rest of the sections. Inspect the end of each track thoroughly to ensure that a mounting bracket has been fixed securely and then attach the whole placement to the beam that lies at the top of the garage door along with the ceiling.
Make sure that the installation of the motor should be done properly and then affix it securely along with the ceiling. You should run all the wires from the motor to the wall switch. In the last, install the safety sensors at the bottom of the tracks.
After completing all the procedures, it is time to connect the garage door to the garage door opener. Don’t forget that electricity is involved in this process and garage door springs are placed under a lot of pressure. Never skip any step in the installation instruction for any reason.